Vladyslav Pereverzyev

Fit check

Load two scans from the same CAD project, for example a bridge and its model. Paint on each one the surface that has to slide over the other and run the test: the part goes in along the best insertion axis, slides and tilts where it has to and stops where it really touches. The points that hold it back are marked in red. Everything runs in your browser, no file is uploaded.

Drag two .stl, .ply or .obj files here
or click to select them

How the fit check works

Both files have to come from the same project, exported in their final position, the way exocad or any other CAD software saves a restoration together with its model. The tool does not align them: it uses the position they already have.

Paint only the surfaces that matter, the intaglio of the crown or bridge and the preparations on the model. Without paint the whole scan counts, neighboring teeth and gingiva included, and the result says little. The tolerance ignores contacts smaller than the value set, 0.02 mm by default.

The part first comes in straight along the best axis the tool finds. From the first contact it moves in steps of 0.25 mm: it slides, tilts or moves sideways toward its seat, trying several starting angles. When nothing takes it further it stops, the label shows how many millimeters are missing and the red areas are the ones in the way of the last stretch. The result is a check on the digital files and does not replace a try-in on the model.

Which files does the fit check accept?

STL, PLY and OBJ. Load the part to insert first, then the fixed part. Both must come from the same project so they share one coordinate system.

Are the scans uploaded anywhere?

No. The files are read by your browser and never leave the computer. Once the page is open the tool also works without a connection.

Does the tool align the two scans?

No. It uses the position the files already have, so both must be exported in their final position from the same project, the way exocad saves a restoration with its model.

Why does the part stop before its seat?

Something on the painted surfaces is in the way: an undercut on a preparation, a margin that is too tight or a contact with a neighboring tooth. The red areas show where to retouch.